Adjusting The Temperature; Temperature Mode; Interior Lighting; Control Lock - AGA marvel MP24FAS4 Serie Instrucciones De Instalación, Operación Y Mantenimiento

USING YOUR ELECTRONIC CONTROL

Adjusting the temperature:

To set or check the set-point temperature (with the
control out of sleep mode), press the "-" or "+" key-
pads. "SET" will be indicated on the user interface
panel and the current set-point temperature will
display and flash. Subsequent presses of the "-" or
"+" keypads will adjust the temperature colder or
warmer respectively. When you have reached your
desired set-point temperature, press the "On/Off"
keypad to accept, or do nothing and the "Set" mode
will time-out in 10-seconds accepting the displayed
temperature as the new set-point.
The available set-point temperature range for your
appliance is -10°F (-23°C) to 10°F (-12°C). If you
attempt to adjust the temperature outside of this
range you will receive an audible notification.
NOTE
Loading warm contents may trigger a temperature
alarm, see temperature alarm page 10. Depending
on the quantity and/or weight of warm contents, it
may take 48 hours for the compartment tempera-
ture to stabilize.
When making temperature set-point changes, it
may take up to 24-hours for the stored contents to
stabilize at your new set-point temperature.
Factors that affect the storage compartment stabi-
lized temperature:
• Changes to temperature setting.
• Room temperature changes.
• Temperature of stored contents.
- Loading warm contents.
- Cold content load will delay the change to a
warmer set-point temperature.
- Warm content load will delay the change to
a colder set-point temperature.
• Usage, (number and duration of the door
openings).
• Installation of the appliance in direct sunlight
or next to a heat source.

Temperature mode:

The temperature mode is preset from the factory in
Fahrenheit (°F) but you have the option to change it
to Centigrade (°C). To change the mode, press and
hold the "-" keypad, while pressing the "+" keypad,
then release the "-" keypad.
The temperature will now be displayed in Centi-
grade (°C). Repeat the procedure to change the
temperature mode back to Fahrenheit (°F).

Interior lighting:

Changing the Tri-Color lighting:
To change the color between white, amber, or
blue, with the control out of sleep mode, momen-
tarily press the "Light" keypad. The keypad will
illuminate. Then press and hold the keypad for
approximately 3 seconds the interior light will start
to cycle through the 3 available colors. On solid
door/drawer product this will need to be done with
the door/drawer open to be able to observe the
colors. Release the keypad when the desired color
is on, and your interior light will be changed to that
color. After selection of color for solid door/drawer
product, the display light feature should be turned-
off, ("Light" keypad not illuminated).

Control lock:

The control panel can be locked to avoid uninten-
tional changes. To lock the control, press and hold
the "Lock" keypad until the display reads "Loc" then
immediately release your finger from the keypad.
The lock icon will flash 3-times and then continu-
ously illuminate. When the control panel is locked,
only the Lock keypad, System Status OK indicator,
and the Alarm indicator are active. To un-lock
the control panel, repeat this instruction until the
display reads "nLc" then immediately release your
finger from the keypad.
NOTE
If the control lock is active (illuminated lock
icon) the control will have to be unlocked
before using the keypad to reset an alarm
condition. See page 9 (Control Lock) for instruc-
tions for unlocking the control.
9