Joerns Oxford Presence Manual De Instrucciones página 8

Oxford
®
Presence
CONNECTION
To make the electrical connection:
Ensure the battery is disconnected and the control box is powered off.
1. Remove the cable grip from the boom using a small flat blade screw driver.
Find and pull through the ends of the wires through the hole in the side of the boom.
2. Connect the bullet terminals on the ends of the wires to the bullet terminals on the end of the wires
from the Integrated APC.
3. Fit the cable grip around the cable 150mm from the point the cable enters the cradle connection pin.
4. Feed any excess wire, including the bullet terminals, through the hole and into the boom.
5. Fit the cable grip back into the hole in the boom, ensuring it is pressed all the way in.
6. Check there is still 150mm of free cable length between the boom and the Integrated APC.
1
3
8
2
5
English