Further Use (Folding) - Mammut AIRBAG TECHNOLOGY 3.0 Instrucciones De Uso

14
Protection Airbag System 3.0
05
E
N
06 To put on the avalanche airbag correctly, thread the
hip belt through the leg strap; close the hip belt (the
hip belt should sit approximately on the hip bone);
tighten the shoulder straps; close the chest strap.
The length of the leg loop can also be adjusted. The
leg loop should fit tightly.
07 Before entering areas with an avalanche risk, re-
move the deployment handle from the pocket and
turn into a T position. To stow the deployment han-
dle, press the button under the grip and twist it into
a vertical position. Place the handle in the shoulder
strap pocket and close the zipper.
08 If you get caught in an avalanche, deploy the airbag
immediately. It is better to use it once too often than
once too little. Pull the deployment handle hard and
decisively.
The airbag will automatically fill in approximately three
seconds. You will hear a relatively loud noise as the
airbag fills.
cm inch size
51.0 20 XL
48.5 19 L
46.0 18 M
06
08

5.2 Further use (folding)

The avalanche airbag can be reused after deploy-
ment. However, after deployment in an avalanche,
your avalanche airbag must be checked by Mammut
Customer Service. This is the only way to guarantee
smooth deployment. If you have used your airbag in
an avalanche, please contact your Mammut retailer.
We strongly advise against using your airbag without
having it checked first.
To prepare your avalanche airbag for further use:
01 Unscrew the cartridge and remove it from the sys-
tem.
02 Open the airbag system pocket zipper.
03 Remove the protective cap, press the deflation but-
ton and press the air out of the airbag. The less air
there is in the airbag, the easier it will be to fold.
02 03
04 Close the airbag system pocket zipper again.
05 Open the airbag zipper from the left to the right
shoulder strap.
04 05
07