General Options; Display Settings; Energy Saving - PURE Verona Manual De Instrucciones

General options

Display settings

You can adjust the brightness and time-out duration of the display for when the unit is switched
on and in standby. To change display options:
1. Press Menu, scroll to 'Display settings' and push the Tune dial.
2. Now choose either 'Active' to change settings that apply when the unit is switched on, or
'Standby' to change settings that apply in standby.
Changing the display time-out duration
Select 'Duration' and choose from the following two modes:
Always on The screen is always set to your preferred brightness level.
Timed off The screen is set to your preferred brightness level when a button is pressed and
then switches off after 7 seconds of inactivity.
Setting your preferred brightness level
Select 'Brightness' and choose from the following options:
Automatic The brightness of the screen adjusts automatically depending on the ambient light
levels in the room (default).
1–10 Turn the Tune dial to vary the brightness level between 1 (very dim) and 10 (very
bright) and push to confi rm your preferred setting.
Set clock
You can manually set the time and date if required. If you have a DAB signal and/or a good FM
(RDS) reception these will be updated automatically. If 'Getting time... ' is displayed at any time,
tune to a DAB or FM station to receive a time signal.

Energy saving

Verona is designed and manufactured to minimize power consumption when the unit is switched
on and to use less than 1 Watt in standby. One way this low power consumption is enabled is by
not collecting and storing Intellitext messages when the unit is in standby. You can override this
option by switching off energy saving mode, but this will increase standby power consumption.
Two energy saving modes are available:
On Verona updates the Intellitext data when you tune to a station that broadcasts
Intellitext. Intellitext data is not collected in standby.
Off Verona collects Intellitext data in standby from the last station you tuned to with
Intellitext, which increases standby power consumption.
Note: When powered by a ChargePAK the unit will switch off when you press the Standby button
and not enter standby, as long as the unit is not connected to mains power.
12