How To Install - uniQam Scout Manual De Usuario

Dash-Cam Mode
uniQam Scout is also available to use as Dash-Cam.
Install the camera inside of the vehicle and record while driving.

1. How to install

– Insert the camera while fl ip over frame housing. (connector on top)
– Connect frame housing to the universal suction mount
– Attach suction mount on the front window.
2. Camera power
– The camera will record by using internal battery.
– By using 12V USB charger, you can recharge and record at the same
time.
When using internal battery only, the camera will be automatically powered off when
internal battery power run out.
3. Dash-Cam recording mode
– Select 'LOOP' mode in video recording mode.
– The camera will start recording and save fi le in every 1 minute.
– When memory is full, it overwrites old data and save new recording
fi le.
– LOOP recorded fi les are named as "LOOPxxxx"
4. Exceptions
– 'LOOP' mode is only available when the memory card has 10% or
more capacity inside.
– When memory space is less than 10%, 'LOOP' mode may not work.
Delete the fi les manually to secure enough space.
– During overwriting, the camera delete 'LOOP' recorded fi le only.
– Normal images and normal videos are NOT deleted by overwriting.
Note
- The camera may not record all events, incidents, or accidents. It is NOT guaranteed.
- Any loss of data shall not be responsibility if the manufacturer.
EN
15 15