Accessories/ Installation Procedure - Kenwood KTC-HR200 Manual De Instrucciones

Accessories/ Installation Procedure

Accessories
1
2
3
En-14
|
KTC-HR200
Installation Procedure
1. To prevent short circuits, remove the key from the
ignition and disconnect the - terminal of the
battery.
2. Install the FM/AM antenna and connect the
..........1
antenna wire to the HD Radio tuner.
3. Connect the HD Radio tuner and the control unit
using the provided connection wire.
4. Make the proper input and output wire
connections for each unit.
5. Install the unit in your car.
..........1
6. Reconnect the - terminal of the battery.
7. Press the reset button on the control unit.
¤
..........2 • Mounting and wiring this product requires skills and
experience. For safety's sake, leave the mounting and wiring
work to professionals.
• Do not install the unit in a spot exposed to direct sunlight
or excessive heat or humidity. Also avoid places with too
much dust or the possibility of water splashing.
• Do not use your own screws. Use only the screws provided.
If you use the wrong screws, you could damage the unit.
• After the unit is installed, check whether the brake lamps,
blinkers, wipers, etc. on the car are working properly.