When Using The Unit; Maintenance / Cleaning; Removing The Collected Water - Celcia MDT3-10DMN3-QA3 Instrucciones De Uso

7. Operating instructions / Drawings

When using the unit

When first using the dehumidifier, operate the unit continuously 24 hours.
This unit is designed to operate with a working environment between 5OC and 35OC.
If the unit has been switched off and needs to be switched on again quickly, allow approximately three
minutes for the correct operation to resume.
Do not connect the dehumidifier to a multiple socket outlet, which is also being used for other electrical
appliances. Select a suitable location, making sure you have easy access to an electrical outlet.
Plug the unit into a 115V~ 60Hz/220~240V 50Hz (Refer to the nameplate located on the side/rear of
the unit) electrical socket-outlet with earth connection.
Make sure the Water bucket is correctly fitted otherwise the unit will not operate properly.

8. Maintenance / Cleaning

Disconnect from mains before maintenance or cleaning.
U se only a damp cloth to clean the enclosure.

Removing the collected water

There are two w ays to remove collected
water.
1. Use the bucket
When the bucket is full, the unit will automatically
stop running, and the Full indicator light will flash.
Slowly pull out the bucket. Grip the left and right
handles securely, and carefully pull out straight so
water does not spill. Do not put the tank on the floor
because the bottom of the bucket is uneven.
Otherwise the bucket will fall and cause the water
to spill.
Throw away the water and replace the bucket. The
bucket must be in place and securely seated for the
dehumidifier to operate.
The machine will re-start when the bucket is restored
in its correct position
NOTES:
When you remove the bucket, do not touch any parts
inside of the unit. Doing so may damage the product.
Be sure to push the bucket gently all the way into the
unit. Banging the bucket against anything or failing to
push it in securely may cause the unit not to operate.
2. Continuous draining
Water can be automatically emptied into a floor
drain by attaching the unit with a water hose
( 12mm) (not included).
Remove the rubber plug from the back of the unit and
store
it in a safe location.
Insert the water hose into the unit from the drain
outlet in the back of the unit as shown in the right
picture. Then lead the water hose to the floor drain or
a suitable drainage facility.
NOTE: When the continuous drain feature is not
being used, remove the drain hose from the outlet
and attach the rubber plug back to the drain outlet.
.
1. Pull out the bucket a little.
2. Hold both sides of the bucket
with even strength, and pull it
out from the unit.
3. Pour the
water out.
70
Fig.5
Fig.6
Fig.7
Remove the
rubber plug
Insert the hose
from the drain
outlet
Fig.8