5. Plug the Ombra* Table Top Compressor into an electrical outlet.
6. In a relaxed, comfortably seated position, pick the nebulizer up out of the
the compressor and start your treatment.
7. When your treatment is complete or during a rest in your treatment, the nebulizer may be placed back
CUP HOLDER
in the
NOTE: The compressor should be unplugged when not in use.
CLEANING AND MAINTENANCE
AIR FILTER
Your Ombra* Table Top Compressor is equipped with a special air filter that will slowly change colour
with use. The original filter is bright white, but it will slowly turn grey with use. Your air filter should be
changed every 30 days, or as visual inspection indicates. The compressor should never be used without
an air filter installed.
To change the filter (Figure 5)
AIR FILTER COVER
1. Remove
degrees. Pull the cap and filter cover out.
2. Remove filter from the cover, and dispose of the old filter.
3. Insert a new filter into the cover, then place the
turn clockwise approximately 90 degrees to tighten.
4. Do not over tighten. There will be resistance when the
CAUTION: Do not wash or reuse the filter. Use only Ombra* Replacement Filters (Part Number:
10554493050). Do not attempt to substitute any other material to act as a filter as this will result in
damage to the compressor and may void your warranty.
FIGURE 5
90˚
NEBULIZER
OWNER'S MANUAL
Refer to the
on how to properly clean your nebulizer.
and the compressor switched off.
by holding the cover and turning counterclockwise approximately 90
included with your reusable AEROECLIPSE* XL BAN for instructions
AIR FILTER COVER
AIR FILTER COVER
CUP
HOLDER. Switch on
back into the compressor and
is securely fastened.
90˚
7
EN