Installing The Device - Trevi Road Patrol DV 5000 Manual Del Usuario

8. Support Motion detection.
9. Support SOS and G-sensor to prevent important files from being overwritten.
INSTALLATION
MICRO SD CART INSERTION
Before you turn on and use the device, you must install a memory card.
1. Insert a Micro SD Memory Card into the slot (4) of the device, paying attention
to the correct insertion side.
2. Press it towards the bottom until you hear a "click" and it is locked inside.
To remove the memory card, push it towards the bottom until you hear a "click"
and unlock it.
Note:
- Insert the Micro SD card correctly to prevent damage to the card or device.
- Format the micro SD card (delete all files) before inserting it into the device. It is
recommended that you back up important files before formatting the card.
- We recommend using micro SD cards CLASS 6 or higher.
- We recommend backing up your micro SD card files once a week. This product is not
a permanent storage device, so please back up important files to avoid being deleted.

INSTALLING THE DEVICE

Clean the windscreen well before installing the device.
1. With the vehicle switched off, connect the car power cable (supplied) to a
cigarette lighter socket of the vehicle.
2. Connect the other end of the power cord to the Mini USB (2) jack of the
device.
3. Insert the support bracket into the bracket hole (1) of the unit.
4. Press the suction cup of the bracket on the windscreen and push the lever of
E n g l i s h
DV 5000