BlueStork P2P Sereie Manual De Instrucciones página 58

9) Enter the WEP key or WIFI password in the window « PASSWORD »
10) Click on « OK » to validate the configuration.
11) Your camera is now installed on WIFI. You can unplug the RJ-45 Ethernet cable from
your camera.
12) Unplug the power supply from the camera, wait 10 seconds, then plug the power
supply again.
13) The re-boot camera is is now functional again and the images can be viewed in the
BLUEVIEW P2P MAC.
Quick Install Guide for p2p Bluestork Cameras (MAC)
58