Installation - Palmer WTP B40 Manual De Usuario

DISPLAY LEDS
6
Located next to the sockets, two-tone LEDs for displaying the status of the corresponding DC output. The
LEDs light up green to signal correct functioning and turn red in the event of a malfunction (short circuit). In
the event of a DC output malfunction, remove the connected low-voltage cable and corresponding effects
device, and check both for short circuiting. Once the source of the malfunction has been removed, the DC
PANTONE Warm Gray 8C
output is ready for operation again. Unaffected DC outputs remain operational even during a malfunction
at one of the other DC outputs.
DC OUTPUTS
7
Two low-voltage connectors with a separately switchable output voltage and maximum 500 mA current for
connecting effects devices with the corresponding load values (9 V / 12 V / 18 V DC / outside: positive / up
to 500 mA).
SWITCH 9 / 12 / 18 V
8
3-way switch for switching the output voltage for low-voltage socket no. 7. Move the switch to the desired
position: 9 V left, 12 V middle or 18 V right. Ensure that the output voltage corresponds to the connection
value of the relevant effects device, and switch the device on only after having adjusted the output
voltage accordingly.
DISPLAY LEDS
9
Located next to the sockets, two-tone LEDs for displaying the status of the corresponding DC output. The
LEDs light up green to signal correct functioning and turn red in the event of a malfunction (short circuit).
In the event of a DC output malfunction, remove the connected low-voltage cable and corresponding
effects device, and check both for short circuiting. Once the source of the malfunction has been removed,
the DC output is ready for operation again. Unaffected DC outputs remain operational even during a
malfunction at one of the other DC outputs.

INSTALLATION

Installation on a pedalboard is possible anywhere where a cross bar is present. Remove the cross bar where
the power supply unit is to be installed, and install the unit there. When installing on the upper edge of the
pedalboard, use an appropriate tool to remove both adjustable articulated feet with M8 threads, and take
out the cross bar attached to the frame. Place one of the supplied M8 nuts in each of the appropriate
recesses on the shorter side of the power supply unit, and simultaneously guide both sides (with the Velcro
tape on the upper side) into the frame's U-shaped profile. In order to be able to attach the L-shaped metal
strip to the adjustable articulated feet, unscrew the M8 nuts on the articulated feet (A), screw on a supplied
M8 flange nut with the flange facing the open end (B) and then screw on the previously removed M8 nut (C).
A
6
PANTONE Warm Gray 8C
7
8 9 8
7
9
B C