Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
b a tte ry de t ai ls
Battery requirements
Roborover requires 4 x "C" size alkaline batteries (not included) . The remote controller
requires 3 x "AAA" size batteries (not included) .
Installing or changing batteries in Roborover
You will know when Roborover's batteries are nearly depleted because he will become
less responsive to commands from the remote controller and his movements will be
slower . To change the batteries in Roborover, first carefully lay him on his side . Do not
balance him or place him near a table edge .
Install the batteries as follows:
1 .
Open the battery
compartment on the
remote controller
using a Phillips
screwdriver (not
included) to remove
the screws on the
battery compartment
cover .
2 .
Insert the batteries
according to the
diagram . Ensure that
the positive and
negative polarities
match the illustrations
inside the battery
compartment .
3 .
Replace the battery compartment cover and replace the screw using the
screwdriver . Do not over-tighten .
batterY details
Battery
compartment
cover
5
Publicidad
Tabla de contenido
