Maintenance And Cleaning; Enviroment Protection - BEAUTY JATA MP373N Instrucciones De Uso

Fourth step: THE TOP OF THE HEAD
• Set the guide to long cutting length and start cutting from the crown forwards against the growth of the hair. In some
cases you will have to cut from the front backwards.
• To leave your hair longer use a comb to lift the hair at the back of the head and cut above the comb; or else hold the
lock of hair between your fingers and cut off the to the desired length. (fig. B).
• Always working your way from the back of the head, gradually cut the hair, shorter each time by reducing the space
between the comb, or between your fingers, to the hair. Frequently comb your hair to check for any differences in its
length and to eliminate the hair, which has already been cut.
Fifth step: THE FINAL TOUCHES
• Do not use any guides for the final touches.
To get an exact hair cut, and the side burns, nape and the area around the ears with straight lines, turn the hair clippers
round and place them at a straight angle with your head so the blade is in slight contact with the skin, and shave downwards.
This way you will get a perfect finish, as if shaving.
VARIABLE THIN OUT FUNCTION
• The clippers come with a practical comb (6) whose function is to cut the hair unevenly.
• Without none cutting guide, slide forwards the variable comb button (7).
• Raise the hair with your fingers or with the comb (14) and turn the hair clippers round (Fig. C). Proceed to cut as shown
in figure D. Part of the hair will go in between the teeth of the comb and will be cut, while the rest of the hair will not
be affected by the cut.
BEARD
• Always remember you must begin with the cutting guides set to the longest cutting position before setting it to a lower
position.
• Start by cutting from the down side of the chin and moving the clipper with soft movements upwards and outwards.
• For the final touches and the edges always use the hair clipper without any guide.
MOUSTACHE
•Comb the moustache downwards.
• Start with the higher cutting guide. Later you may use the shorter cutting guides.

MAINTENANCE AND CLEANING

• Before doing anything, make sure the hair clipper is unplugged from the mains.
• For a correct cleaning it is advisable to remove the block of the blade. To do so press on the blade with your thumb
(Fig. E). The block will become loose. Clean with the brush (15) the blade and the inside of the hair clippers
• To replace the block of the blade slot it in by the bottom (Fig. F), and press on the top until it clicks into place (Fig. G).
• Use a slightly damp cloth to clean the outside of the appliance.
• Do not use to clean chemical products or abrasives, metallic scourers and similar, which may deteriorate the surfaces.

ENVIROMENT PROTECTION

• This appliance is equipped with two Ni-Mh batteries.
• To remove the batteries, follow the next steps:
1.Remove the rating label of the appliance and release with a small screwdriver the screw placed below.
2.Slide totally forwards the cutting length regulator (8) and release the two screws placed in the lower part of
the appliance.
connexion.
• Dispose the appliance according to the local garbage regulations.
• Dispose the batteries according to the local garbage regulations.
• Never throw away the appliance or the batteries to the rubbish. So you will help to the improvement of the
environment.
• The batteries must not be mixed with other domestic residues
14