Clarke American Sanders CE7 Pro Edgers Manual Del Operador página 8

ENGLISH
EN
Machine Set-up
Fig. 4.1, 4.2 Electrical Connection
The unit is equipped with a grounding NEMA L5-15P
locking plug (fig 4.1). Connection to an electrical
source is made through an extension cord (optional
42300A). Connect the plug on the extension cord to a
wall outlet matching one of the two shown (fig. 4.2).
Plug the appliance into the matching connector then
twist clockwise until the cables are locked.
NOTE: The extension cord must be sized to a
minimum of 14 AWG2 conductor with ground not
exceeding 50' in length and have for ends a
NEMA 5-15P plug and NEMA L5-15R connector.
An extension cord sized smaller than 14 AWG or
greater than 50' in length will overheat and
potentially cause a fire.
DANGER: This appliance must be grounded.
Should an electrical malfunction
occur, the grounding conductor
provides a path to harmful charge.
Do not connect this appliance to
any other wall outlet than than
one of those shown in fig. 3.2.
Consult an electrician if there is
reason to doubt that the wall
outlet is not wired correctly. Do
not remove pin on the extension
cord. Do not use the appliance
with a damaged cord or
connectors.
Fig. 5.1 Controls
All controls are conveniently located on the handle
providing comfort and security. The master control
switch (all models) is activated with a rocking motion
as shown in figure 5.1a. The switch will remain
activated until it is deliberately deactivated or if there is
a loss of power. The speed control switch (models
07170A and 07176A only) varies the abrasive disc
speed (fig. 5.1b). The switch is operated with a
rocking motion. The switch will remain in a particular
setting until it is deliberately changed.
-8- Clarke ® American Sanders Operator's Manual (EN) - CE 7 Pro, SE7 Pro, CE7 Pro+, SE7 Pro+
Figure 4.1
Figure 4.2
Figure 5.1