Operating Instructions - Clarke American Sanders EZ Sand Manual Del Operador

ENGLISH
EN

Operating Instructions

Follow this procedure for sanding floors:
1. Move machine to work location. Decide the best
approach to sanding the desired area. When
sanding the area, work so that you are moving
away from the power supply. This will help to
avoid entanglement with the power cord and
reduce the need to move the power cord as
frequently.
2. Install the sandpaper. Use the same procedure
outlined in MACHINE SETUP for installing the
pad(s), to install the sandpaper. The sandpaper
uses a hook and loop system which is identical to
how the pads attach to the drivers. Center the
sandpaper over the pad and press it against the
pad until the hooks on the pad have set into the
sandpaper.
WARNING: Injury can occur if the machine is
connected to a power source while
installing the pads or the sandpaper.
Disconnect the machine before
installing the pad/sandpaper.
3. Connect the machine to an appropriately fused and
grounded circuit.
4. While holding the handle, reach down and slide the
knurled locking collar up the handle tube and hook
it to the pin in the tube by rotating it (see figure 7).
Lower the handle down to a comfortable position.
5. To run the machine, push the interlock button (1),
and apply pressure to the levers (2). To stop the
machine, release the levers (2). See figure 8.
CAUTION: To prevent damage to the flooring
and to reduce swirling, keep the
machine in motion while the motor
is running.
NOTE: For sanding cuts and sandpaper, see
page 10.
-8-
2
1
®
Clarke American Sanders Operator's Manual (EN) - EZ Sand
Figure 7
2
Figure 8