Troubleshooting - Clarke American Sanders EZ Sand Manual Del Operador

Troubleshooting

Problem
Motor will not start.
Motor fails to start / runs
sluggish.
Fuse / Circuit Breaker repeatedly
trips.
Handle feels loosely connected
to base machine.
®
Clarke American Sanders
Cause
No power.
Interlock not depressed.
Defective switch/ Bad connection
Low voltage from excessive length
or undersized extension cord.
Defective start switch.
Defective motor low voltage
Low voltage.
Bad connection.
Defective motor.
The latches have loosened up.
Operator's Manual (EN) - EZ Sand
ENGLISH
EN
Action
Check power supply and connection
Depress Interlock before activating
control lever.
Contact an authorized American
Sanders Technology Dealer.
Use a 14 Ga extension cord, not to
exceed 50' length.
Contact an authorized American
Sanders Technology Dealer.
Contact an authorized American
Sanders Technology Dealer.
Eliminate extension cord.
Locate power source closer to
work site. Have voltage checked by
a qualifed electrician.
Contact an authorized American
Sanders Technology Dealer.
Contact an authorized American
Sanders Technology Dealer.
To tighten latches, loosen the lock
nut, screw in the latch hook and
then tighten the lock nut.
- 9 -