Using The Sleep Timer; Adjusting The Tone (Remote Control Only); Adjusting The Brightness Of The Front Panel Display (Remote Control Only) - Yamaha TSX-B232 Manual De Instrucciones

When the specified time has elapsed, the system will turn off automatically.
Press repeatedly

ADJUSTING THE TONE (remote control only)

1
ADJUSTING THE BRIGHTNESS OF THE FRONT PANEL
Press repeatedly

USING THE SLEEP TIMER

2
3
DISPLAY (remote control only)
Press SNOOZE/SLEEP repeatedly to specify
the time after which the system will turn off.
You can specify 30, 60, 90 or 120 minutes.
When you select a time, the sleep timer is turned on, and the
sleep indicator ( ) is shown in the front panel display.
If you press SNOOZE/SLEEP while the sleep timer is activated,
the sleep timer setting will be canceled.
1 During playback, press the LOW, MID, or
HIGH EQ button on the remote control.
Select the tone to be adjusted (LOW, MID, HIGH).
2 Press  /  to adjust the tone.
3 Press ENTER on the remote control to
complete the operation.
You can also press the EQ button that you pressed in
Step to complete the settings.
1
If you want to adjust another frequency band, return to
step and press the EQ button for the frequency
1
band that you want to adjust.
Press DIMMER repeatedly on the remote
control.
The brightness of the front panel display will change in
the order shown below.
AUTO 1 (bright) 2 (medium)
back to AUTO
When AUTO is set, the brightness of the front panel display is
adjusted automatically with the Illumination sensor (☞ P. 3).
Ensure that the sensor is not covered.
3 (dim)
17
En