Troubleshooting - Yamaha TSX-B232 Manual De Instrucciones

If there is a problem with the unit, check the following list first. If you cannot resolve the problem with the suggested
solutions or if the problem is not listed below, turn off and unplug the system, and consult the nearest authorized Yamaha
dealer or service center.
General
Problem
The speakers make no sound.
Sound suddenly turns off.
Sound is cracked/distorted or
there is abnormal noise.
The unit does not operate
properly.
The system turns on but
immediately shuts off.
A digital or high-frequency
equipment produces noises.
The clock setting has been
cleared.
The iPod does not play back at
the alarm time even if the alarm
source is set to iPod.
Clock flashes and the unit cannot
be operated.
Alarm does not sound.
The front panel display indicates
"ALARM not work" and can't
set the alarm.
The unit turns the system off
unexpectedly.
Front panel display becomes dim. The front panel display's brightness setting is set
18
En

TROUBLESHOOTING

Cause
The volume might be set to the minimum level,
or muted.
The source may be incorrect.
The headphones are connected.
The volume of a connected external device is not
loud enough.
The sleep timer (☞ P. 17) may be set.
Input source volume is excessive, or volume of
this unit is excessive (especially Bass).
The unit may have received a strong electrical
shock such as lightning or excessive static
electricity, or power supply may have dropped.
The unit may be placed too close to the digital or
high-frequency equipment.
The unit remained unpowered for more than one
week.
The iPod is not set in the iPod dock.
The CLOCK switch is in the SET position, and
the clock settings are in progress.
The CLOCK switch is in the OFF or SET position. Set the CLOCK switch to the ON position.
The automatic system-off function may have
operated.
to AUTO.
Solution
Adjust the volume level.
Select the correct source.
Remove the headphones.
Raise the volume of the external device.
Turn the system on and play the source again.
Adjust volume with VOLUME, or adjust Bass with EQ
(☞ P. 17). If an external device is playing back, lower the
volume of the external device.
Turn the system off, and disconnect the power cable. Wait
about 30 seconds, reconnect the power cable, and turn on
the system.
Place the unit farther away from the equipment.
If the power supply is interrupted for about one week, the
time setting may be reset. If this occurs, please reset the
clock (☞ P. 5).
Set the iPod in the iPod dock (☞ P. 2).
Set the CLOCK switch to the ON or OFF position.
This unit will turn the system off when 60 minutes have
elapsed without any operation being performed after
stopping playback of the USB device or the CD, or if the
system has been on for 12 hours or more without any
operation being performed.
Change the brightness setting to something other than
AUTO (☞ P. 17). Alternatively, ensure that the
illumination sensor (☞ P. 3) is not obscured.