Package Contents; System Requirements; Hardware Installation; English - i-tec U3HDDOCK Manual De Instrucciones

I-tec USB 3.0 Docking station for SATA Hard Disk is a simple docking station for
connecting 2.5" or 3.5" SATA HDD to any PC without using USB External case. Owing to
USB 3.0 Superspeed connection and owing to SATA interface you are able to gain much
higher transmission speeds.

PACKAGE CONTENTS:

• i-tec Docking Station for SATA Hard Disk
• USB 3.0 cable (80 cm)
• Power adapter
• User Guide

SYSTEM REQUIREMENTS:

Hardware:
Available USB 3.0 port (up to 5 Gbps transmission speed) or USB 2.0 port (up to 480
Mbps transmission speed only).
Operating system:
Windows 7 32bit/64bit, Windows 8 32bit/64bit, Windows 8.1 32bit/64bit, Windows 10
32bit/64bit.

HARDWARE INSTALLATION:

1) Insert 3,5" SATA HDD beside dock station edges to the bottom. Make sure, that the
SATA connectors on the hard drive are facing the SATA ports in dock station first.
2) Insert 2,5" SATA HDD similarly, but not completely beside the edges. There is also
ledge helping you with connection of your HDD to SATA ports and SATA connectors
will be connected in right way.
3) Make sure, that power switch is in OFF position and then connect the included
power adapter.
4) Connect the included USB cable from docking station to an available USB port on
the computer system.
5) Turn on the power switch, and ensure that the power LED indicator is active.
NEW HDD FORMAT:
1) Right click „Computer".
2) Select „Manage".
3) Left click „Disk Management".
4) Choose „Unallocated" HDD with right capacity.
5) Right click disk area and select „New Simple Volume", then click „Next".
6) Use max. capacity of Volume and click „Next".
7) Select „Assign the following drive letter" and click „Next".
8) Select „Format this volume with the following settings" (use original settings).
Click „Next" and „Finish".
9) Format of HDD will process. Format time depends on capacity of volume. After
finish is HDD visible in OS.
SOFTWARE INSTALATION:
Windows 7/8/8.1/10:
Device is supported by OS and no drivers are needed. But pls, check, if you have installed
the latest drivers of your USB 3.0 controller in your PC.
Quick Start
| 5

ENGLISH