General Safety Instructions - RED CASTLE RC 2 Instrucciones De Uso

General safety instructions
BEFORE USING YOUR CAR SEAT FOR THE
FIRST TIME, READ ALL OF THE INSTRUCTIONS
CAREFULLY RESPECTING THE RECOMMENDATIONS
AS INDICATED IN ORDER TO GUARANTEE YOUR
CHILD MAXIMUM SAFETY. IMPORTANT! KEEP FOR
FUTURE REFERENCE.
The RC 2 car seat can be installed with or
without the PRIMAFIX base (optional accessory).
Installing the RC 2 car seat
in the car
(with the car seat belts)
WARNING
• Never leave the child unsupervised.
• The RC 2 group O car seat conforms to the
European safety standard ECE R-44/04. It is
suitable for children from birth to less than
10kgs (around 9 months).
• The RC 2 group O car seat is classed in the
«universal» category of retaining devices for
children. It can be adapted on the majority
of car passenger seats. It is possible to fit
the device correctly in the vehicle if the
manufacturer's vehicle handbook states that
it will take "universal" retaining devices for
children of this age group.
• The RC 2 group O car seat must always be used
in the rear facing position. It must be fixed in
your vehicle EXCLUSIVELY with a 3 point seat
belt (static or automatic) which conforms to
the ECE-16 regulation or its equivalent.
• Seat belt lengths vary from car to car. We
suggest you check that this car seat can be
used in your vehicle.
• The RC 2 group O car seat
must
in
equipped
airbag, this may prove very
dangerous.
• ALWAYS attach your baby with the safety
harness even when you are not using the RC 2
car seat in the vehicle.
• The manufacturer can only guarantee the
safety of the car seat if it is used by the first
time owner. We strongly suggest that you do
not use a second hand car seat.
never be installed
front passenger seats
with a front
• Do not continue to use this car seat when
used as a reclined cradle once the child can
sit unaided.
• It is dangerous to place this car seat on a
raised surface: for example, on a table...
• Do not use the car seat for more than 5 years.
Intensive use can cause deterioration not
always visible.
• Never take the baby out of the car seat for
any reason while the vehicle is in motion.
• Always use the restraint system.
• When used as a reclined cradle, this car seat
is not intended for use during long periods of
sleep.
WARNING: Never install the RC 2 group O car
seat on the front passenger seat if the car is
equipped with a front airbag. This could cause
death or serious injury. If you have a front
airbag use the car seat in the rear of the car.
Both in the front and in the rear of the car, the
car seat must always be used in a rear facing
position.
1. Put the handle into position 1a (fig. 18) (see
chapter on «Adjusting the seat back and
handle positions»).
2. Buckle the car seat belt.
3. Feed the lap belt of the car through the
guides at the front of the car seat (located
below the car shell). (fig. 1).
4. Then, slip the diagonal belt around the rear
of the car seat and feed it through the guide
located at the back of the car seat (fig. 2).
IMPORTANT: check that the car seat belt does
not slip underneath the adjustment lever
(fig. 3).
5. Choose the seat back position best suited to
your child's weight:
1 Position A up to 5kgs
2 Position B up to 5kgs
Only to be used in
the car with the
3 Position C
Primafix base
4 Position D from 5kgs to 10kgs
6. Pull firmly on the diagonal belt to take up any
slack (fig. 4).
GB
(fig.13)
(fig.14)
(fig.15)
(fig.16)
17