Troubleshooting - Broil King 18674 Manual Del Usuario

TROUBLESHOOTING

PROBLEM
SMELL OF GAS
Leak detected at cylinder,
regulator or other connection.
Flickering Burner Flame or
Low Temperatures on HIGH
Setting
Burner Not Lighting
Ignitor Not Working
Decreasing Heat, "Popping
Sound"
Regulator Humming Noise
POSSIBLE CAUSE
SHUT OFF LP CYLINDER VALVE AT ONCE.
DO NOT USE THE APPLIANCE UNTIL LEAK IS SEALED.
1. Regulator fitting loose.
2. Gas leak in hose/regulator or control valves.
1. Excess flow safety device has been activated
in connection between cylinder and barbecue.
1. Out of LP gas, gas supply not connected.
2. Ignitor issue.
3. Excess flow safety device has been activated.
4. Regulator is not fully connected to the cylinder
valve.
5. A leak in the system causing the excess flow
device to activate.
6. Orifice(s) blocked.
7. Hose is twisted.
1. Ignitor battery is dead
2. Ignitor wire(s) not connected
3. Electrode misaligned on burner
4. Ignitor malfunction
1. Out of LP Gas.
2. Venturi blocked.
1. Cylinder valve opened too quickly.
CORRECTIVE ACTION
1. Tighten fitting and "Leak Test." (page 3)
2. See authorized service center.
1. Turn LP cylinder valve off then turn all burners to
OFF position. Disconnect the regulator from the
cylinder. Wait two minutes. Re-attach regulator to
the cylinder. Open the cylinder valve slowly. Wait
one minute. Light grill as per "Lighting" (page 4)
1. Refill LP gas cylinder, check connections to supply.
2. Try manually lighting burner with a match. See
"Lighting" (page 4). If burner lights successfully, it is
an ignitor issue. See "Ignitor not Working" below
3. Follow "Flickering Flame or Low Temperatures on
HIGH setting" solution above.
4. Tighten the regulator hand wheel.
5. Leak test connections to determine loose fitting.
Tighten fitting. Leak test system.
6. Remove burner, clean orifices with a pin or fine
wire. Do not drill orifices.
7. Straighten hose.
1. Replace battery
2. Ensure main burner and side burner electrode wires
are all connected
3. Realign electrode and clear any surrounding debris
from area
4. Use "Match Lighting" procedure. (Page 4)
1. Refill LP Gas Cylinder.
2. Remove burner, clean venturi.
1. Open cylinder valve slowly.
7