Mechanics; Front Side; Rear Side - dBTechnologies VIO L210 Manual Del Usuario

MECHANICS

The module's ergonomics and the quick assembly in line arrays are guaranteed by:

FRONT SIDE

1) Lower anchorage system for the connection of other modules or the DRK-210 fly-bar (in a stacked
configuration).
2) Retractable brackets for anchoring to a higher module (or to the DRK-210 fly-bar in a flown configuration).
3) Pins for fastening the retractable brackets in open/closed position [2].

REAR SIDE

4) Central bracket. Equipped with a graduated label, allows selecting the angle of the line array module.
1° steps are possible (range: 0-10°).
5) Pins for fastening the angle of inclination: only one pin is needed in the flown configuration, and 2 in
the stacked one. For that purpose, refer to the figures on page 9.
6) A movable arm with a loop. Inserted into the bracket [4], it mechanically fixes the chosen angle with
the pins [5].
RIGHT AND LEFT SIDE
7) Handle balanced according to the weight of the cabinet.
8) Back handle for easier lifting the rear of the module, when the front side is fixed.
The VIO-L210 modules are also equipped with 2 rain
covers on the rear side, in order to protect the
amplifier from water and allow operation even in
critical weather conditions. They will be no longer
shown in the following drawings, for simplicity.
For further information regarding the fly-bar (see the
ACCESSORIES section), please refer to the relevant
manual.
VIO-L210
36
English
Cod. 420120248 REV. 1.1