Antenna Range Adjustment; Managing Transmitters - Neat D-POS II Manual De Usuario

3.8

Antenna range adjustment

The antenna range can be tuned by adjusting the antenna power
field. This is done by setting DIP7 to On (high power) or OFF (low
power) in combination with the potentiometer P1 where clockwise
rotation increases field power.
O
Low
P1
Picture 3. Antenna power adjustment with DIP7 and potentiometer P1
3.9

Managing transmitters

D-POS II can work as a radio receiver. Adding radio transmitters is
done by using button B1.
3.9.1 Program a radio transmitter id code
1. Press the button B1
2. After 3 seconds the LED starts flashing red (150ms on/400ms off)
every 2 seconds according to below where the number of
flashes corresponds to a radio position, e.g. 3 flashes equals
radio position 3:
1 flash - 2 flash - 3 flash - 4 flash - 5 flash - 6 flash - 7 flash - 8 flash -
1 flash - ...
3. Release the button B1 at the desired radio position.
4. Activate the radio transmitter.
5. If the radio code is successfully received, D-POS II flashes green
rapidly for 2 seconds whereafter the unit returns to normal mode.
3.9.2 Erase a radio transmitter Id code
Follow steps 1-3 in 3.9.1 above.
After releasing the button B1 at the desired radio position, press
button B1 for more than 3 seconds. The deletion is indicated by the
LED flashing green rapidly for 2 seconds whereafter the unit returns
to normal mode.
8
DIP7
On
High
Power
P1
D-POS II - NE41 17028-00 v1.0