7. To remove any batter baked onto the cooking plates, pour a small amount of cooking oil onto the hardened
batter. Allow to set for 5 minutes, then wipe softened batter off with a paper towel or soft cloth. Remove
stubborn stains with a plastic mesh puff or pad. For best results, use only products with directions stating that
it is safe for cleaning non-stick cooking surfaces. Do not use steel wool or coarse scouring pads.
8. The exterior finish should be cleaned with a non-abrasive cleaner and a soft, damp cloth. Dry thoroughly.
Hints For Care and Use of Ceramic Non-Stick Surface
•
To avoid scratching the non-stick surface, do not stack objects on the grill or griddle cooking plates.
CAUTION: DO NOT USE COOKING SPRAYS. THEY CAN CAUSE A BUILD-UP ON THE COOKING PLATES AND
MAY AFFECT THE NON-STICK PERFORMANCE OF THE PRODUCT.
•
Use medium to low heat for best cooking results. Very high temperatures can cause discoloration and shorten
the life span of any non-stick surface. If higher temperatures are necessary, preheat on medium heat for a few
minutes.
•
Use only nylon, plastic, or wooden utensils with care to avoid scratching the non-stick surface.
•
Never cut food on the grill or griddle plate.
•
Remove stubborn stains with a plastic scouring pad and mild dish washing liquid;
DO NOT USE STEEL WOOL as it will damage the non-stick surface of the cooking plates.
•
Steps For Stain Removal and Proper Care of Your Ceramic Non-Stick Coating
1. Identify stained areas on the cooking surface and sprinkle some baking soda on the stains.
2. Moisten the baking soda to get a paste like texture by adding some water.
3. Let the paste stand for a few minutes on the stains (not more than an hour)
4. Rub with a soft damp cloth or lightly scrub with a plastic scouring pad, wipe clean and dry thoroughly.
NOTE: Do not rub vigorously when using a plastic scouring pad and NEVER use a metal scouring pad as this
may damage the non-stick coating.
5. Repeat the cyctle once again if necessary The performance and non-stick property of the ceramic non-stick
coating will not be affected due to stains.
Storage
1. Make sure unit is unplugged and fully cooled.
2. After cleaning, fold handle and store for future use.
3. Never wrap cord tightly around appliance. Do not put any stress on cord where it enters unit, as this could
cause cord to fray and break.
9