Replacing Fuse - Pihernz DYNASCAN 10M Manual De Instrucciones

Notes:
- We suggest not use cigar lighter as it often bring down the voltage.
- Locate the power cable away from high temperature, moisture and fire.
- Use the transceiver power cable without remove the fuse holder from the cable.
1.- Connect red power cable with the positive terminal (+) of the battery.
2.- Connect black power cable with the terminal (-) of the battery.
3.- Connect the DC power cable to the transceiver's power supply connector.

REPLACING FUSE:

This transceiver adopt 15 A, 250 V fuse.
If the fuse blows, determine the reason, then correct the problem.
After the problem is resolved, replace the fuse with one of the same type as supplied with the
transceiver. If newly installed fuses continue to blow, disconnect the power cable and contact your
authorized dealer or an authorized service centre.
1.- Pull the two fuse cover in difference direction and open it.
2.- Replace the broke fuse with good one, and close the fuse holder.
3.- Be sure to use suggested fuse, or it might damage the transceiver.
English - 7 -