Getting Started - INTERTECHNO PIR-3000 Manual De Instrucciones

FIN
Käyttöohje
Ei käytettäväksi himmentimelle.
Käytä vain kuivissa tiloissa.
Älä asenna lähelle magneettikenttiä tai sähkömagneettisia kenttiä.
Vältä metallin päälle asentamista, sillä silloin kantama lyhenee.
Vaatimustenmukaisuusvakuutus (CE) on saatavana osoitteessa
www.intertechno.at/CE
GB
PIR-3000
The wireless motion sensor is designed for indoor use.
PIR-3000 has 67 million possible fixed codes and controls all self-learning
wireless receivers even wireless gongs made by intertechno.
The automatic switch-off feature makes it ideal for lighting in cellars,
corridors, garages, etc.
Simply stand it up or use the magnet to mount it on the wall or ceiling.
With the intertechno IT-MG MASTERGATE, you also receive a push
notification on your smartphone as soon as someone is in the detection
area.
At the same time, a siren with a wireless receiver can also be activated as
an alarm system.

GETTING STARTED

Before mounting:
Open the motion sensor using a cross-head screwdriver (Fig. 1)
Remove the battery fuse.
Settings
When open you can adjust the following settings (Fig. 2)
A Light sensitivity H/M/L (Day/Evening/Night).
H = Activates 24h, day and night.
This setting is recommended for the wireless gong.
M = Activates under 20 +- 5 lux. If it becomes lighter it won't turn on.
L = Activates under 10 +- 5 lux. It won't turn on if it becomes lighter.
B Turn off time (5 secs/1 min/5 mins/10 mins)
After leaving the detection range or the last movement is detected, the
PIR-3000 switches off after the set time.
Give the motion detector 15-20 seconds to ensure reliable detection
and activation using the new settings each time after changing the light
sensitivity or encoding.
Operating instructions
PIR-3000
›