Premium PWA0510N Manual De Usuario página 28

Aire acondicionado de ventana
Tabla de contenido

Publicidad

Fig.9
Fig.12
Fig.13
Sash
,,
Storm window
11/2 MIN
frame or other
(38 mm)
obstruction
Fig.10
Board
thickness
as required,
for proper
pitch to rear,
along entire
sill. Fasten
with nails or
screws.
,,
5
Drive 1 / 2 (13mm) locking screws through frame
holes into window sash (Fig.9/10)
6
To secure lower sash in place, attach right angle
,,
sash lock with 3 / 4 (19mm) screw as shown(Fig.11).
7
Cut foam seal and insert in the space between the
upper and lower sashes (Fig.12).
If AC is Blocked by Storm Window
Add wood as shown in Fig.13, or remove storm
window before air conditioner is installed.
If Storm Window Frame must remain, be sure the
drain holes or slots are not caulked or painted shut.
Accumulated Rain Water or Condensation must be
allowed to drain out.
Removing AC From Window
Turn AC off, and disconnect power cord.
Remove sash seal from between windows, and
unscrew safety lock.
Remove screws installed through frame and frame
lock.
Close (slide) side panels into frame.
Keeping a firm grip on air conditioner, raise sash
and carefully rock air conditioner backward to
drain any condensate water in base of unit. Be
carefully not to spill any remaining water while
lifting unit form window. Store parts WITH air
conditioner.
11
Fig.11
, ,

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Pwa0810nPwa1215n

Tabla de contenido