Quick Creation Of Bar Codes; Quick Creation Of 2-D Codes; Permanent Stencils - Walter Surface Technologies SURFOX Manual Del Usuario

5
Label creation
Bar codes
u
To place the bar code object on the label, do the following:
1. In the Toolbox, click the Bar Code button.
2. Click the position on the label, where you want to place the object. Bar
Code Wizard dialog box opens.
3. Define the contents for the bar code object.
4. To advance to the next step of the wizard, click on the Next button.
5. Follow the onscreen instructions in the next steps.
6. Click the Finish button.
2-D codes (QR, AZTEC, MAXICODES, etc.)
u
To place the 2-D code object on the label, do the following:
1. In the Toolbox, select the desired 2-D type of code.
2. Click the position on the label, where you want to place the object. Bar
Code Wizard dialog box opens.
3. Define the contents for the 2-D code object.
4. To advance to the next step of the wizard, click on the Next button.
5. Follow the onscreen instructions in the next steps.
6. Click the Finish button.

Permanent stencils

Custom made stencils from a .bmp, .jpg, .tiff, .dwg, .ai, .cdr, .doc, .pdf
document may be ordered and reused hundreds of times. Many sizes are
available. Refer to the ACCESSORIES list in this manual. For increased
durability, neutralize the stencil with SURFOX-N, rinse after use and store flat
between two cardboard pieces or for more flexibility and to avoid curling on
the edge of the stencil, place the stencil in a jar filled with water.
10