Adjusting Top Plate Tension; Using The Timer - Buffalo L501 Manual De Instrucciones

UK

Adjusting Top Plate Tension

Use the Allen key supplied to adjust the tension of the top plate.
Turn clockwise to tighten, anti-clockwise to loosen.
Note: It is possible to tighten the plate so that it sits in the open position (if required).
BUFFALO recommend the appliance is disconnected from the power supply and allowed to cool before any
adjustments are made.

Using the Timer

The digital timer with audible alarm can be set from 1 second to 15 minutes
The timer provides an audible alarm after the set time expires. It provides no electrical
control over the unit
START/STOP: Press START/STOP to start timer, press again to stop. The timer will provide an audible
alarm after the set time. The alarm will beep 10 times and the display will continue to flash until timer is
reset (press the START/STOP button)
UP: Press UP to add extra time
DOWN: Press DOWN to reduce time
PROGRAM:There are a total of 6 programmable timer settings. The default factory program settings are
given below
To change the length of a program select the program you want to change by scrolling using the
PROGRAM button. Adjust the program time by using the UP and DOWN buttons. Press START/STOP
to commence the count down. The new program time will be automatically stored
If the unit is left without power for more than 24hrs the timer settings will revert to the
factory defaults
3
START/STOP
PROGRAM
UP
DOW N