Rear Panel; Switching The Power On And Off - Roland MOBILE CUBE Manual Del Propietário

Panel Descriptions

Rear Panel

8
988
7. Security Slot (
http://www.kensington.com/
8. Grounding terminal
927
Depending on the circumstances of
a particular setup, you may experience
a discomforting sensation, or perceive that
the surface feels gritty to the touch when
you touch this device, microphones
connected to it, or the metal portions of other
objects, such as guitars. This is due to an
infinitesimal electrical charge, which is
absolutely harmless. However, if you are
concerned about this, connect the ground
terminal (see figure) with an external ground.
When the unit is grounded, a slight hum may
occur, depending on the particulars of your
installation. If you are unsure of the
connection method, contact the nearest
Roland Service Center, or an authorized

Switching the Power On and Off

941
* Once the connections have been completed, turn on power
to your various devices in the order specified. By turning on
devices in the wrong order, you risk causing malfunction
and/or damage to speakers and other devices.
1. Make sure that all volume controls on the
MOBILE CUBE and connected devices are
set to 0.
2. Turn on all the devices connected to the
MOBILE CUBE's INPUT and AUX IN jacks.
3. Turn on the MOBILE CUBE.
10
)
Roland distributor, as listed on the
"Information" page.
Unsuitable places for connection
• Water pipes (may result in shock or
electrocution)
• Gas pipes (may result in fire or explosion)
• Telephone-line ground or lightning rod
(may be dangerous in the event of
lightning)
* Due to interference from external devices or the power
outlet to which you're connected, a noticeable amount of
noise may be emitted from this unit.Connecting the ground
terminal with an external ground can reduce such noise.
9. Battery Compartment
Insert six AA batteries. Refet to "Inserting
Batteries"(p. 5).
* Use only manganese or alkaline batteries (LR6).
You cannot use any other type of battery.
The use of alkaline batteries are recommended as the unit's
power consumption is relatively high.
4. Adjust the volume levels for the devices.
5. Before switching off the power, lower the
volume on each of the devices in your
system and then TURN OFF the devices in
the reverse order to which they were
switched on.
921
* To prevent malfunction and/or damage to speakers or other
devices, always turn down the volume, and turn off the
power on all devices before making any connections.
7
9