Miele MF 02 10-20 Instrucciones De Montaje página 10

10 von 26
Parts included
Quantity Mat. no. Designation
1 EZL 235 electronic
4 Standoff
1 MFM 2-5 coding plug
1 "1N1-16, 2N1-16 L, N" wiring harness
1 "1N1-16, 2N1-16 bus" wiring harness
3 Brown connecting wire, 90mm
1 Blue 6-pin screw-terminal strip
1 Green 7-pin screw-terminal strip
1 Orange/gray terminal strip 3X3-4
1 Blue/green/yellow terminal strip 3X3-4
1 Accessory module
1 Module mounting bracket
2 Fixing bracket for module mounting bracket
4 Raised-head screws, CEM 6 x 12
6 M12 cord connector
6 M20 cord connector
1 Wiring diagram
Danger due to incorrectly carried out service and repair work
WARNING
Danger due to incorrectly carried out service and repair work.
There is a risk of serious damage, injury and even death if service and repair work is carried out incorrectly.
A
Service and repair work should only be carried out by a suitably qualified electrician with specialist training,
knowledge and experience.
A
All appropriate safety regulations must be taken into account.
A
Read the technical service documentation (TSD) before starting service work.
Risk of cuts
CAUTION
Components are sharp.
Risk of cuts.
A
Protective gloves should be worn and the edge protection, mat. no. 05057680, should be used.
Installing module 2 for liquid dispensing 7-12
A
Remove the machine lid; see the model-specific TSD.
A
Install the module mounting bracket (3) with fixing brackets (4) onto the crossbar. See Fig. 1.
A
Secure the module (1) with standoffs (2) onto the mounting bracket (3). See Fig. 1.
A
Install the terminal strips (5) in the pre-punched holes on the crossbar. See Fig. 1.
A
Secure cable screw connectors (1) to the top of the rear panel. To do this, push the appropriate pre-punched holes
out of the top of the rear panel; see Fig. 2.
A
Connect the green 7-pin screw-terminal strip to plug ST8 on the module; see Fig. 3.
A
Connect the green 6-pin screw-terminal strip to plug ST12 on the module; see Fig. 3.
16.03.2018 Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
M.-Nr. 10717761