Miele BSS 28 Instrucciones De Montaje página 6

6 von 16
Danger due to incorrectly carried out service and repair work
WARNING
Danger due to incorrectly carried out service and repair work.
There is a risk of serious damage, injury and even death if service and repair work is carried out incorrectly.
A
Service and repair work should only be carried out by a suitably qualified electrician with specialist training,
knowledge and experience.
A
All appropriate safety regulations must be taken into account.
A
Read the technical service documentation (TSD) before starting service work.
Risk of cuts
CAUTION
Components are sharp.
Risk of cuts.
A
Protective gloves should be worn and the edge protection, mat. no. 05057680, should be used.
Installing the peak-load cutout kit
A
Remove the machine lid; see the model-specific TSD.
A
Clip the wiring harness' terminal block (1) into its allotted position on the traverse. See Fig. 1.
A
Lay the wiring harness and place it in the cable holders (2). See Fig. 1.
A
Connect the wiring harness to ST33 (3) on the ELP 235 electronic. The existing bridge connector can be disposed
of. See Fig. 1.
A
Break off one of the covers at the top of the back panel for the cable feed-through.
A
Feed the cable through the top of the back panel.
A
Reinstall the machine lid.
en-US
el
Οδηγίες τοποθέτησης του συστήματος διακοπής λειτουργίας κυκλώματος λόγω φορτίου αιχμής BSS28
Αιτία: Το σετ εξαρτημάτων χρειάζεται για τη σύνδεση ενός πλυντηρίου ρούχων της σειράς PW4 ή PW8 σε ένα σύστημα
διακοπής λειτουργίας κυκλώματος λόγω φορτίου αιχμής.
Περιεχόμενα μέρη
Αριθμός Κωδικός Ονομασία
προϊόντος
1 Δέσμη καλωδίων N1L_ST33, X3-3
1 Στυπιοθλίπτης
16.03.2018 Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
M.-Nr. 10712541