Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
10. Move throttle lever to "Fast" position, shown here
as a rabbit.
Fast
Stop
J
Throttle
Lever in
STOP
position
NOTE: For a warm engine, be sure the throttle lever is
in the "Fast" position.
To start the engine for the vecy first time:
11. Make sure throttle lever is in "Fast" position
(indicated on the engine as a rabbit).
12. Push primer bulb firmly 5 times, waiting 2 seconds
between each push.
To start engine thereafter:
11. Make sure throttle lever is in "Fast" position
(indicated on the engine as a rabbit).
12. Press primer bulb firmly 3 times, waiting
2 seconds between each push. For a warm
engine, DO NOT press primer bulb.
13. When starting engine, position yourself as
recommended
below. Grasp handle and pull recoil
starter lightly until you feel some resistance, then
pull briskly.
I
i
\\
I
i
14. Return starter grip handle slowly. DO NOT let rope
"snap back" against starter.
WARNING
When
starting
engine,
pull cord
slowly
until resistance
is
felt and then
pul! rapidly
to avoid kickback.
If engine
starts
and fails to continue
to run or if increased
resistance
is felt during
starting
pull attempts,
squeeze
trigger
on spray gun.
NOTE: Always keep the throttle lever in the "Fast"
)osition when operating the pressure washer.
WARNING
• DO NOT touch
hot surfaces
and avoid hot exhaust
gases.
• Allow
equipment
to cool before
touching.
The pressure
washer
must be at least 5 feet from
structures
having
combustible
walls
and/or
other
combustible
materials.
• Keep at least 3 feet of clearance
on all sides
of pressure
washer
for adequate
cooling,
maintenance
and servicing.
Reflective
exhaust
heat may damage
fuel tank causing
fire.
Code of Federal
Regulation
(CFR)
Title 36 Parks,
Forests,
and Public
Property
require
equipment
powered
by an internal
combustion
engine
to have a spark
arrester,
maintained
in effective
working
order,
complying
to USDA
Forest
service
standard
5100-1C
or later
revision.
In the State of California
a spark
attester
is
required
under section
4442
of the California
Public
resources
code.
Other
states
may have similar
laws.
CAUTION
DO NOT move pressure
washer
while
running.
Always
use handle
to lift equipment.
NEVER
pull on hoses
to move
equipment.
Publicidad
Tabla de contenido
