Connections; Descriptions Of Terminals; Basic Style - Pioneer PLX-1000 Manual De Instrucciones

Connections

Be sure to turn off the power and unplug the power cord from the power outlet whenever making or changing connections.
Refer to the operating instructions for the component to be connected.
Connect the power cord after all the connections between devices have been completed.

Descriptions of terminals

1 PHONO OUT terminals
Connect the audio cables (included) here.
2 SIGNAL GND terminal
Connect the ground wire (accessory). This helps reduce noise when
connecting an analog player.

Basic style

Connects to a power outlet using the included power cord. Wait until all connections between the equipment are completed before connecting the
power cord.
Refer to the operating instructions for the component to be connected.
Connecting to a pre-main amplifier and component
Pre-main amplifier, components, etc.
1 Connect the audio cable and ground wire to the [PHONO] input terminal of the pre-main amplifier or other component.
If this product is connected to a pre-main amplifier or component that does not have a [PHONO] terminal, sufficient volume and sound quality
cannot be obtained. In this case, use the PHONO equalizer.
Make sure to connect the ground wire. If the unit is not properly grounded, a power hum (humming sound) occurs.
2 Connect the power cord.
Connects to a power outlet using the included power cord. Wait until all connections between the equipment are completed before connecting the
power cord.
Before connecting to the outlet (AC outlet) mounted on the connected equipment, check the wattage displayed on the outlet. (This unit con-
sumes 9 W of power.)
10
En
1 2
Ground wire
Audio cable
3
3 AC IN
Connects to a power outlet using the included power cord. Wait until
all connections between the equipment are completed before con-
necting the power cord.
Be sure to use the included power cord.
L
R
Power cord
Rear panel
To power outlet