Teac TASCAM TT-M1 Manual Del Usuario página 4

Connection
• Be sure to turn off the CD-X unit before con-
necting the TT-M1 to the CD-X.
On the rear panel of the CD-X, an ACCESSORY
terminal is provided for each of the two CD
drives. Connect the TT-M1 cable to the desired
terminal. Orient the cable connector so that the
arrow is located on the upper side of the connec-
tor.
Calibration
The TT-M1 must be calibrated to accurately
detect the turntable's rotating speed.
• As the calibration results are saved to the CD-
X unit, the product is only required to be cali-
brated once after it is installed to the player.
However, when the product is re-installed, it
must be calibrated again.
• The calibration results are saved for each CD
drive. When two TT-M1 units are connected
to the CD-X, perform calibration on a drive
basis. Calibration is also required when a TT-
M1 that was connected to one drive is re-con-
nected to another drive.
4 English
1 Turn on the CD-X.
2 Lower the TT-M1 roller onto the turntable
and press the POWER switch.
• A record does not have to be placed on the
turntable.
The LED comes on and the following is dis-
played on the CD-X's remote controller:
3 Turn the turntable on to rotate at 33 rpm.
4 Press the Á / π
controller while pressing and holding down
the SHIFT key.
Calibration begins and the following is dis-
played on the remote controller:
5 Calibration is completed in five seconds and
the following is displayed on the CD-X's
remote controller. The normal display is then
resumed momentarily:
key on the CD-X's remote