Miele BWS 02 Instrucciones De Montaje página 8

Produktgruppe 512
8 von 26
en
Parts required
Quantity Mat. no.
1 07555850
Note
This service and repair work should only be carried out by a suitably qualified electrician (with specialist training, knowledge and
experience, and recent related work experience) in accordance with all appropriate local and national safety regulations.
Servicing, modification, testing and maintenance of electrical appliances should only be carried out in accordance with all appropriate
legal requirements, accident prevention regulations and valid standards. All regulations of the appropriate utility supply companies and
standards relating to safety (not limited to electrical safety) are to be complied with.
Danger!
Even with the machine switched off, mains voltage may be applied to some components.
Before any service work is commenced, the machine must be disconnected from the mains. Suitable measurements must be made to
ensure that this is the case.
A general visual check should always be carried out.
Incorrect conversion or service work could lead to a risk of fire.
Note
The kit, Mat. no. 07555850, for PW 6163, PW 6243 and PW 6323, contains the following:
1 branch pipe 75 x 50, 45°
1 pipe bend 50 x 45°
4 hose clips SGL 50-70
1 hose I
1 hose II
1 connection piece
1 pipe bend DN 50 x 45° (pipe bend hose fastening)
1 ring (reinforcing ring for pipe bend hose fastening)
1 connection piece 1
1 connection piece 2
1 holding plate
2 raised-head screws CE M6 x 16
1 adapter for vapour/foam dissipation
2 raised-head screws 4 x 15
1 foam adhesive tape 0.5 m
1 pipe 110 x 500
1 pipe 110 x 50
1 sleeve 110
3 bends 50 x 87
1 pipe 50 x 100
Fitting instructions - BWS 02 foam compensator (vapour and foam dissipation kit), Mat. no. 07553950.
List of illustrations:
Fig. 1: Side casing removal
Fig. 2: Branch piece fitting, view from right
Fig. 3: Hose I and hose II pre assembly
Fig. 4: Pipe bend hose fixing pre assembly
Fig. 5: Drain connection, view from right
Fig. 6: Side casing through-feed fitting
Fig. 7: Side casing fitting
Fig. 8: Fitting foam adhesive tape
14.04.2010 Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
Designation
Fitting kit - BWS 02 vapour/foam dissipation
M.-Nr. 07553950