Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
1. safety precautions
2. test Procedure
Instead of the oilpressure controlling switch, the oil pressure gauge has to be connected.
Then start the engine and control the pressure on the gauge.
•
Disconnect the oil pressure switch from electric circuit.
•
Remove the oil pressure controlling switch.
•
Attach the appropriate adapter ANK.. (see table on page 2)
and connect it with the hose of the tester by quick coupling.
•
Start the engine - oil pressure is produced now - and observe the gauge.
•
Compare the measured values with the manufacturers specifications.
•
Switch off the engine.
•
Return the vehicle to its original condition.
3. technical data, delivery unit
1
Gauge DS 80, with dual scale 0...10 bar / 0...140 psi, G 1/4, gauge hose 1.00 m
10 Adapters with nipple for quick coupling
1
Angular adapter ET 285,
1
Plastic case, dimensions L/W/H 380/280/90 mm
Weight 2.5 kg
Technical modifications reserved.
4
Work according to safety instructions of automobile trade!
The tester may only be used by suitably trained personnel!
english
02/13
Publicidad
Tabla de contenido
