Locating - Find A Mislaid Item - Loc8tor Lite Manual Del Usuario

LOCATING – FIND A MISLAID ITEM
LOST
• Press and hold down the ON button until the Loc8tor
beeps and lights flash.
• Press the button that your item / Tag is allocated to.
• Loc8tor will beep and status light will flash rapidly as it's
searching for the Tag.
• When a Tag is detected the locating
lights will light up and the audio will start.
• With the Loc8tor in your hand turn
around slowly completing a full circle.
• As you point in the right direction and
then move nearer to the item, the
audio pitch and frequency of beeps
will increase, and lights on the Loc8tor
change from red to amber to green.
• Once a circle has been completed, face
the direction of the strongest audio and visual signal and
walk in this direction.
• When you see three green lights the Tag is very close by.
• To guide you right in, the Loc8tor now changes to
'zooming in' mode (pictured). As you get closer amber
then red lights illuminate and the audio pitch increases.
FOUND
To stop a search press ON/OFF button or the locate
button your Tag is allocated to.
www.loc8tor.co.uk 7