Pipe Finishing Abrasives; Carbon Brushes; Preventive Maintenance - Walter MATE III Serie Manual Del Usuario

Buffing Drums
Heavy cotton drums used with polishing pastes.
Ideal for enhancing and brightening existing finishes, taking out stains in
metals and bringing outa new lustre in work surfaces.
Optimal working speed 1700-2200 RPM.
Dia. Width Arbor
4 3/4" 2" 5/8"-11

PIPE FINISHING ABRASIVES

BLENDEX™ Strip Belts
Quick and efficient method to produce in-line finishes on small diameter
tubing and pipes made of steel, stainless steel and aluminum.
- Produce new sheen and lustre in tarnished pipe work.
- Ideal for enhancing and brightening existing finishes, taking out
stains in metals and bringing out a new lustre in work surfaces.
Width Length
1 3/16" 25"
1 3/16" 25" Medium - Maroon
1 3/16" 25"
1 3/16" 25" Super Fine - Grey
Belt Drive Rollers
For use with BLENDEX™ Conditioning Strip Belts. This belt drive roller
is made of resistant polyurethane. The ribbed design ensures positive drive
of belts. The large stainless steel side plates prevent belts from slipping
off.
Grit Order No.
Multi-ply cotton 07-T 425
Grit/Color Order No.
Coarse - Tan 07-H 242
07-H 243
Fine - Blue 07-H 244
07-H 245
16

CARBON BRUSHES

When the carbon brushes are worn down, the Auto-Stop feature will
automatically turn the machine off in order not to damage the motor. The
brushes must then be replaced.
Use only genuine WALTER carbon brushes. These brushes are specially
made for this tool. They will maintain their high performance standard and
ensure maximum life of the motor.
To check or replace carbon brushes:
1. Disconnect the tool from power supply.
2. Unscrew and remove carbon brush service window.
3. Carbon brushes may be pulled from their holders after lifting spring
and detaching the connector.
4. Replace brushes if necessary. Always replace them in pairs.
5. Check that the new brushes move freely in their holders. To help seat
the carbon brushes properly after they have been installed, use the
power tool without applying a heavy load for at least 30 minutes.
However, when the carbon brushes require replacement, it is recommended
that the tool be sent to a WALTER Factory Service Center or a WALTER
Authorized Service Center. Apart from changing the brushes, your power
tool will be cleaned, inspected and lubricated as required.

PREVENTIVE MAINTENANCE

Your WALTER power tool should be properly maintained to insure
continued high performance.
Use low-pressure compressed air to blow out dust from the motor through
the vent openings.
Clean dust and dirt deposits from the exterior of the tool. Clean the power
cord to prevent deterioration from oil and grease and check for possible
damage to cord or plug.
NOTE: Damaged cord sets must be replaced. Refer to Spare Parts List for
the ordering number.
17