Aiwa CX-ZL10 Manual De Instrucciones página 16

[+Tj-i~J
/,
-.
(J.
.. .—. ...
w
When the clock is set, the ":" between the hours and minutes
flashes. When the power cord is plugged into an AC outlet for
the first time after purchase or when the clock setting is canceled
due to a power failure, the entire clock display flashes.
Use the remote control.
1
2
3
Press CLOCK once while pressing SHIFT on the
remote control.
Within 4 seconds, press 4 or -to designate
the hour and the minute.
Holding these buttons down will vary the time rapidly.
Press II.
The clock starts from 00 seconds.
To view
the clock when another display is
in the display
Press CLOCK while pressing SHIFT. The time is displayed for 4
seconds and then the original display reappears. However, the
clock cannot be displayed during recording.
To switch to the 24-hour standard
Press CLOCK once while pressing SHIFT and then press
within 4 seconds.
Repeat the same procedure to restore the 12-hour standard.
~
If the display flashes when the clock is displayed, it indicates
that the clock has stopped due to a power failure or the removal
of the power cord. The current time needs to be reset.
2
The unit can be turned off automatically at a specified time.
Use the remote control.
1
Press SLEEP while pressing SHIFT on the remote
control.
2
Within 4 seconds, press + or -10 specify
the time until the power is turned off.
The time "changes between 5 and 240 minutes in 5-minutf?
steps.
Specified time
While the sleep timer is in operation, the display is dimmer
than usual.
To check the time remaining until the power is turned off
Press SLEEP once while pressing SHIFT. The remaining time
is displayed for 4 seconds.
To cancel the sleep timer
Press SLEEP twice while pressing SHIFT so that "SLEEF'OFF"
appears on the display.
~6
ENGLISH