Craftsman 917.387241 Manual Del Propietário página 6

The operation of anylawnmower c an
resultinforeignobjects thrownintothe
eyes, which can result in severe eye
damage. Always wear safety glasses or
eye shields while operating your lawn
mower or performing any adjustments or
repairs. We recommend a wide vision
safety mask over spectacles or standard
safety glasses.
HOW TO USE YOUR LAWN MOWER
ENGINE SPEED
The engine speed was set at the factory
for optimum performance. Speed is not
adjustable.
ENGINE ZONE CONTROL
CAUTION: Federal regulations require an
engine control to be installed on this lawn
mower in order to minimize the risk of
blade contact injury. Do not under any
circumstances attempt to defeat the
function of the operator control. The blade
turns when the engine is running.
• Your lawn mower is equipped with an
operator presence control bar which
requires the operator to be positioned
behind the lawn mower handle to start
and operate the lawn mower.
TO ADJUST CUTI'ING HEIGHT
• Raise wheels for low cut and lower
wheels for high cut.
• Adjust cutting height to suit your
requirements. Medium position is best
for most lawns.
• To change cutting height, squeeze
adjuster lever toward wheel. Move
wheel up or down to suit your require-
ments. Be sure all wheels are in the
same setting.
NOTE: Adjuster is properly positioned
when plate tab inserts into hole in lever.
Also, 9-position adjusters (if so equipped)
allow lever to be positioned between the
plate tabs.
Lower Wheeis Plate Tab
For High
Cut
Raise Wheels For Low Cut
Lever
CAUTION: Do not operate your lawn
mower without mulcher door in locked
position, discharge deflector in place, or
approved grass catcher in place.
NOTE: Your lawn mower has been
shipped ready for mulching operation. To
convert to discharging operation, you must
install the discharge deflector attachment
induded with your mower.
TO INSTALL DISCHARGING DEFLECTOR
• Lift door upward on it's hinge until the
deflector frame can be hooked over the
door mounting bracket as shown.
• Release the door to rest against
deflector frame.
• To return to mulching operation, reverse
the above steps and be sure door is in
locked position.
BEFORE STARTING ENGINE OIL
Your lawn mower is shipped without oil in
the engine.
• Be sure mower is level and area around
oil fill is clean.
• Remove engine oil cap w/dipstick and fill
to the full line on the dipstick.
• Use 20 ozs. of oil. For type and grade
of oil to use, see "ENGINE" in Mainte-
nance section of this manual.
• Pour oil slowly. Do not over fill.
• Check oil level before each use. Add oil
if needed. Fill to full line on dipstick.
• To read proper level, tighten engine oil
cap each time,
• Reinstall engine oil cap and tighten.
• Change the oil after every 25 hours of
operation or each season. You may
need to change the oil more often under
dusty, dirty conditions.
6