Sears Kenmore 116.30612 Manual Del Propietário página 14

TO REMOVE DUST BAG
!
WARNING
Always unplug power cord from elec-
trical outlet before performing any
service on vacuum.
Pull out on the
bag cover
release located
near the top of
the bag cover.
Bag Cover _J
Bag
Pull the bag
cover forward
and lift up.
Remove and
lay aside.
Grasp the dust bag
collar and pull gen- \.
tly, carefully remov-
ing the dust bag.
Throw away the
used dust bag.
/Dust
Bag
Do not reuse.
•
BagHelder Check the bag
holder and the
motor safety ill-
ter• If either is
blocked, check
- Meter
Safety TROUBLE-
Filter SHOOTING.
!
CAUTION
NEVER REUSE A DUST BAG. Very
fine materials, such as carpet fresh-
ener, face powder, fine dust, plaster,
soot, etc. can clog the bag and
cause it to burst before it is full.
Change bag more often when vacu-
uming these materials.
TO REPLACE DUST BAG
Unfold the
new dust bag. Dust
Bag
Fold the safety
seal tab on the _[_._ .=F--_...._ safety
new dust bag '/'__.t Tab
away from the
opening that _-'_/
fits on the bag
holder.
NOTE: See PARTS AND FEATURES for
Bag number.
Insert the dust bag
onto the bag holder
completely by holding
the bag collar.
Place the dust bag
cellar into position.
Tuck the bag
behind each of
the four bag
retention corner
flaps shown here.
Be sure the bot-
tom and sides of
the dust bag are
completely within
bag cavity prior to
replacing the bag
COVer.
Bag
Retention
Corner
Flaps
Position the bag
cover so its
positioning tabs
fit into the body
positioning tab
slots.
Close the bag
cover.
You will hear a
distinct snap
when cover _s
securely closed.
Check to see
that the dust bag
is fully enclosed in the bag cover.
14