Handle Assembly - Sears Kenmore 116.30612 Manual Del Propietário

!
WARNING
ElectricalShock Hazard
Do not plug into the electricalsupply
untilthe assembly is complete. Failure
to do so could result in electrical shock
or injury.
Before assembling vacuum, check the
PACKING LIST on the cover of the separate
Repair Parts List. Use this list to verify that
you have received all the components of
your new Kenmore vacuum.
Remove the tape located below the dust
cover/filter cover on the motor case.
Tape
Attach
stretch hose
end to noz-
zle as
shown.
HANDLE ASSEMBLY
Screw
Remove the screw located just below the
top edge of the back of the vacuum.
Position the handle as shown in the illustra-
tion below.
Slide the handle into the opening at the top
of the vacuum.
Handle
Screw
Hole
Insert the screw so it passes through the
handle into the vacuum.
Begin to tighten the screw with your fingers.
It may be necessary to adjust the handle
slightly.
5