Installation Steps - AirLive WN-5000R Guía De Instalación Rápida

Installation Steps

1. Please install your network cards first before the Router.
Connect the power, Lan cable and Wan cable to the back.
2.
3. Use your wireless card to do a site survey, the default SSID is
"airlive" and Channel is "11".
4. If you need to change router configuration, please follow the
procedure below:
The Router default IP address is 192.168.2.1 Please make
sure your computer IP is in the same subnet as the router
(i.e. 192.168.2.X)
Open the web browser and enter 192.168.2.1 When asked
for the Login and Password, just type airlive for login name
and airlive for Password.
Wireless Mode Setting
This page include all primary and major parameters for the wireless mode
setting. Any parameter change will cause the device to reboot for the new
setting to take effect.
Wireless Modes: AP, AP Bridge-Point to Point,
AP Bridge-Point to Multi-Point, and AP Bridge-WDS
The default mode is set to AP. You can change it to another mode.
802.11n Wireless Router
WN-5000R
English
5
5