Installation - Futurelight PRH-Digital Manual Del Usuario

INSTALLATION

Attaching the screen brackets
Always refer to the screen user manual before attaching the screen brackets!
The number of fasteners used will vary, depending upon the type of screen.
Please note that some screens must not be inclined over a certain degree due to thermal reasons.
Procedure:
Place the two adjustable screen brackets against the back of the screen.
The hook-shaped part should point upwards and the fixing knobs should face away from the screen -for
overhead rigging it is the other way round.
Check which mounting drill-holes your screen has, then choose the corresponding screws.
Attach the screen brackets to the back of the screen using the corresponding toothed lock washers. The gap
between the rails and the top and bottom of the screen should be the same.
Use the corresponding hole in the multiwasher that matches your screw size.
If the screen has a curved back you may have to place spacers between the two screen brackets and the
screen. Make sure that the screen brackets do not press against the screens rear panel.
Always tighten the screws by hand first to ensure that they are the correct thread size. Using incorrect
screws can cause permanent damage to the device.
Make absolutely sure that the screws grip along their entire length into the threaded drill-holes of the screen
and that they are screwed tight. At the same time, you must also make sure that the screw threads do not
protrude too far into the inside of the screen, as this could damage sensitive parts.
If screws don't get three complete turns in the screen inserts or if screws bottom out and bracket is still not
tightly secured, damage may occur to screen or product may fail.
Attaching the screen on the FUTURELIGHT PRH-Digital für LCD/Plasma
For heavy devices, the installation must be carried out by two persons or with mechanical lifting equipment!
Align the two screen brackets (both must be set to the same position) and tighten the knobs so that nothing
can be displaced while the screen is being hooked.
Hook the screen on to the screen mounting from above. Then fasten the lock plate.
Caution! FUTURELIGHT accepts no liability for damages caused by incorrect assembly or by
improper use.
34/90 00029992.DOC, Version 1.3