Adjust The Exhaust Adaptor; Connecting Ductwork - GE JVM1490 Instrucciones De Instalación

MOUNT THE OVEN
A4.
Cabinet Front
Cabinet Bottom Shelf
Oven Top
4 Attach the oven to the top cabinet.
5 Insert 2 self-aligning screws
"-28 x 3
1
( ⁄
4
top cabinet holes. Turn two
full turns on each screw.
NOTE: Use self-aligning screw,
JVM1790 and self-aligning screws,
on JVM1490, SCA1000, and SCA1001.
7
Tighten the outer two screws to the top of the
oven. (While tightening screws, hold the oven in
place against the wall and the top cabinet.)
8 Install grease filters. See the Owner's Manual
packed with the oven.
Installation Instructions
(continued)
Filler Block
Equivalent to
Depth
of Cabinet
Recess
Self-Aligning Screw
") through outer
1
⁄
4
6 Tighten center
screw completely.
"-28 x 2 ", on
1 ⁄ 5 ⁄
4 8
"-28 x 3
1 ⁄ 1 ⁄
4 4
A5. ADJUST THE EXHAUST
ADAPTOR
Open the top cabinet and adjust the exhaust adaptor
to connect to the house duct.
A6.

CONNECTING DUCTWORK

",
1 Extend the house duct down to connect to
the exhaust adaptor.
2 Seal exhaust duct joints using duct tape.
14
Damper
Back of
House Duct
Oven