Placement Of Mounting Plate; Removing The Mounting Plate; Finding The Wall Studs - GE JVM1490 Instrucciones De Instalación

Ocultar thumbs Ver también para JVM1490:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1
PLACEMENT OF THE MOUNTING PLATE
.
REMOVING THE OVEN FROM
A
THE CARTON/REMOVING THE
MOUNTING PLATE
Remove the box containing the installation
1
instructions, filters, exhaust adaptor, damper
and the small hardware bag. Do not remove
the Styrofoam protecting the front of the oven.
Fold back all 4 carton flaps fully against carton
2
sides. Then carefully roll the oven and carton over
onto the top side. The oven should be resting in
the Styrofoam.
Styrofoam
3
Pull the carton up and off the oven.
4
The mounting plate is attached to the back of the
oven. Remove the two screws holding it to the oven.
The plate will be used as the rear wall template and
for mounting the oven to the wall.
5
Set the oven upright. Remove and properly discard
plastic bags and Styrofoam.
6
Open the oven door and remove the styrofoam
pack from inside the oven. Remove the tape
covering the turntable hub.
Installation Instructions
Carton
.
B

FINDING THE WALL STUDS

Wall
Studs
Center
1
Find the studs, using one of the following
methods:
A. Stud finder – a magnetic device which
locates nails.
B. Use a hammer to tap lightly across the
mounting surface to find a solid sound.
This will indicate a stud location.
2
After locating the stud(s), find the center by
probing the wall with a small nail to find the
edges of the stud. Then place a mark halfway
between the edges. The center of any adjacent
studs should be 16" or 24" from this mark.
3
Draw a line down the center of the studs.
THE OVEN MUST BE CONNECTED TO AT LEAST
ONE WALL STUD.
8
OR

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Jvm1790Sca1000Sca1001

Tabla de contenido