Specifications - 3M 110XL Serie Instrucciones De Uso

Alligator Pocket/Belt Clip
LCD Display
Audio Alarm Opening
(Buzzer)
110XL-Series Label

SPECIFICATIONS

Size .2 x 2.0 x .2 in. (8. x . x . cm)
Weight . oz. ( g)
Ingress Protection Rating IP
Sensor Electrochemical (factory replaceable)
Operating Humidity  – 90% (non-condensing)
Readout Direct read LCD
Range 0-99 ppm (CO)
0-200 ppm (H
Alarm Indicators Visual: Flashing LCD display and red LED
Audio: 8 dBA @  foot (0. cm) buzzer
Tactile: Internal vibrator
Alarm Readings Low, High, Low Battery, Over Range , TWA, and STEL alarms
Alarm Settings See alarm settings in the table below
Reading Resolution  ppm (readings start at  ppm)
Test Function Self-test on circuitry, battery and alarms. Automated sensor test reminder.
Sensor Replacement Factory replaceable
Intrinsic Safety CSA (US) - Class I, Div I, Group A, B, C, D, TA
Visual Alarm LED
110XL-CO
(Carbon Monoxide)
110XL-H S
(Hydrogen Sulfide)
2
On/Off/Menu Button
Sensor Inlet
S)
2
6
SPECIFICATIONS (cont.)
Power
Battery Life
Radio Frequency Protection
Keypad
Operating Temperature
Sensor Accuracy (after
calibration)
Fig. 
Non-contaminated
environment
Certified calibration gas*
Warranty
* A gas analysis certificate of the calibration gas is available if requested.
Gas
Sensor Read by Display Reading
Symbol Sensor Range Resolution
Carbon 0 - 99
CO Monoxide ppm  ppm
Hydrogen 0 – 200
H2S Sulfide ppm  ppm
Using a certified gas with a concentration other than the one listed for this instrument and sensor when
conducting a calibration or calibration verification test (Bump test) will produce inaccurate readings. This
means that higher levels of the gas being monitored may be present and could result in overexposure and
cause sickness or death. For proper use, see supervisor or User Instructions, or call M in U.S.A.,
-800-2-60. In Canada, call Technical Service at -800-267-.
Permanently mounted, non-rechargeable .6- volt Lithium battery (factory
replaceable)
2 years from activation (maximum 6. alarm hours –  minutes/day)
<0% deviation of alarm level when subjected to 0MHz,  Watt Radio
@ 2 ft (6 cm)
One button operation
See table below
Carbon Monoxide (CO) – Less than ± 2% of the displayed reading or
 ppm, whichever is greater
Hydrogen Sulfide (H S) - Less than ±2% of the displayed reading or
2
2 ppm, whichever is greater
An environment containing less than 0. ppm of hydrocarbons, 0. ppm of
CO, 0.2 ppm of H S, 0.2 ppm of Ammonia, 0. ppm of Hydrogen and 0.2
2
ppm of other gasses not normally found in the air.
Refers to a calibration gas sold by M or produced by an ISO 900:2000
certified calibration gas manufacturer. The certified accuracy of the
calibration gas components must be listed on the calibration gas container
and traceable to National Institute of Standards and Technology (NIST) or a
national measurement institute standard reference material.
2 years for sensor and electronics (see WARRANTY section)
Required Factory Factory
Calibration Factory Set Set
Gas Set Low High TWA
Concentration Alarm Alarm Alarm
200
 ppm  ppm ppm  ppm
0 ppm 0 ppm  ppm 0 ppm  ppm
WARNING
7
Factory
Set Operating
STEL Temperature
Alarm Range
200 - to 22 ˚F
ppm (-20 to 0 ˚C)
- to 22 ˚F
(-20 to 0 ˚C)