Electrical Connections - Refco AQUASWITCH Manual De Uso Y Mantenimiento

FIXING METHODS
1) Use the waterproof double sided foam supplied to adhere the AquaSwitch
to the side or base or the tray. Surfaces should be flat, free from grease,
dust and water when fixing. Allows 24 hours for full adhesion.
2) Screw the AquaSwitch to the wall of the tray or suitable bracket. Do not
drill or screw into the AquaSwitch in any way other than by the fixing
slots provided.

ELECTRICAL CONNECTIONS

Disconnect all power supplies before starting installation or maintenance
work. This control is intended for use inside the enclosure of host equip-
ment. Wiring and connections are for internal wiring only. It is recommen-
ded to use a fuse in the circuit which supplies the AquaSwitch 3 A ma-
ximum. The Relay contacts are electrically isolated from the supply and
control circuit.
Caution! Terminate spare wire end of unused relay connection.
Connections
Supply
RED
BLUE
REFCO Manufacturing Ltd.
Industriestrasse 11
CH-6285 Hitzkirch (Switzerland)
European
L LIVE PHASE
N NEUTRAL
Telefon +41 41 919 72 82
Telefax +41 41 919 72 83
Info@refco.ch www.refco.ch
USA
L1 PHASE 1
L2 PHASE 2