Publicidad
Use the list below to help solve minor problems.
What's
the problem?
Carpet cleaner won't run
Low suction
Cleaning solution won't dispense
Brushes won't rotate
Low suction in hose during tool use
What
to do
,/
Make sure the carpet cleaner is plugged in firmly.
,/
Check the fuse or breaker.
,/
Empty the recovery tank; it may be full and the
automatic shut-off engaged.
,/
Make sure recovery tank lid is securely latched.
,/
Make sure tool mode lever is in proper position.
,/
Make sure recovery tank latches are properly
secured.
,/
Make sure nozzle front is properly snapped in
place.
,/
Clean recovery tank screen.
,/
Make sure solution tank is securely in place.
,/
Refill the solution tank if it is empty.
,/
Set Brush Speed Selector to ON.
,/
Clean brush filter.
,/
Make sure tool mode lever is in proper position.
,/
Make sure recovery tank lid is securely latched.
,/
Make sure tool mode lever is in proper position.
,/
Make sure recovery tank latches are properly
secured.
,/
Make sure nozzle front is properly snapped in
place.
,/
Clean recovery tank screen.
,/
If suction is still not satisfactory after reviewing
this checklist and a clog in the hose is suspected,
take carpet cleaner to a Sears Service Center for
servicing.
26
Publicidad
